The safety operation procedures of the board frame filter are as follows:
1. Plate filter machine operators, maintenance workers must pass through training, certified after the assessment, certification, and hold certificates.
2. All operators must wear labor protection (including overalls, hats, shoes, gloves, etc.).
3, when cleaning the work site, it is strictly forbidden to use water to wash the electrical equipment, cable, signal line, on-site operation box, and equipment transmission components, and must not be rinsed with water.
4, the work site should be kept neat and clean, and the equipment is "five no leaks" (no loose, no water, no oil, no leakage, no air leakage).
5. Manual Turn off the filter machine hydraulic cylinder pressure cannot be higher than the set pressure to prevent tailings of the tail plate.
6, manual pull filter board, when the filter plate draws in place, the button should be released, and cannot be forced to pull to prevent damage to the filter plate.
7. When the maintenance personnel replace the filter plate, the hydraulic stations should be stopped from the hydraulic station, the cleaning device, and the injection extrusion system.
8. During the operation, problems, should immediately press the emergency stop on the box panel.
9. The operation of all pressure pipes, valves, containers, instruments, etc. of this product should be implemented in accordance with relevant state regulations.
10. Before any overhaul or inspection of this unit, the "Power-on Maintenance" system should be strictly enforced. When conducting a single-alone commissioning or operation, there should be special personnel, and both parties should work with communication to prevent errors.